Page 1 of 1

Mediamonkey as front for subsonic service

PostPosted: Fri Aug 31, 2018 8:03 am
by FlexQ
Hi,

Is it possible to use mediamonkey as a streamer for subsonic server ?

Best Regards,
Henrik

Re: Mediamonkey as front for subsonic service

PostPosted: Fri Aug 31, 2018 10:55 pm
by toolman
You could try to actrivate the DNLA feature in Subsonic:
Settings > DNLA/UPNP > Mark Enable DLNA server.

Re: Mediamonkey as front for subsonic service

PostPosted: Sat Sep 01, 2018 5:58 am
by FlexQ
Hi toolman,

Thanks for your reply, it is quite a long time since i last played with dlna, and then it was not possible to use over the internet.

Is there a solution to that today?

/Q

Re: Mediamonkey as front for subsonic service

PostPosted: Sat Sep 01, 2018 8:05 am
by toolman
If you just search the internet "DLNA over Internet" you'll find that you'll need to set up a VPN to connect to the DLNA service if you're not on the same LAN as your DNLA-server.
Subsonic does a good job at streaming your media to the internet so I just wonder what benefits you would get from using Mediamonkey as a DLNA client.

Re: Mediamonkey as front for subsonic service

PostPosted: Sat Sep 01, 2018 11:03 am
by FlexQ
I dont, i just like the client.

But, if a VPN client is needed, I will find another solution :)

Thanks for your help