Folders scanning

Need help? Post your questions here.

Moderator: moderators

Folders scanning

Postby universechoes » Sun Jul 21, 2019 1:24 pm

Cannot scan folders with greek font. Raspberry pi 3 with osmc
universechoes
 
Posts: 3
Joined: Fri May 26, 2017 10:01 am

Re: Folders scanning

Postby universechoes » Mon Jul 22, 2019 8:30 am

No answer perhaps because it was not so clear what i asked. So i repeat. I have installed subsonic on raspberry pi with operating system OSMC. I have attached via usb a hard disk call Matrox. The scan folder is /media/Maxtor/Music. When i press scan media folders now, subsonic start scanning but when find folder with greek characters stop scanning. If i change in english continue scanning but when find subfolder with greek character stop again
universechoes
 
Posts: 3
Joined: Fri May 26, 2017 10:01 am

Re: Folders scanning

Postby 3Dscrewer » Wed Jul 24, 2019 8:18 pm

I have had a similar problem with other Linux Versions. It seems that is a problem during setup of Linux. You need the right language and UTF (?) ISO setting.

For better explaining...
I am running Nextcloud/Ubuntu in an virtual environment, using W10Pro Drives. Since I'm German I have had the same Problem during scan because äöüß.
I was researching a lot in google and found that it was the Problem of wrong language and keyboard setting during setup .... but you can change it.
Im not that Linux Nerd .... try google or the specific OS Forum, but I think it is the right direction
3Dscrewer
 
Posts: 197
Joined: Tue Feb 13, 2018 1:11 pm

Re: Folders scanning

Postby universechoes » Wed Jul 24, 2019 9:05 pm

Thanks for the reply. I am searching to find a solution. From OSMC forum i did not find any solution
universechoes
 
Posts: 3
Joined: Fri May 26, 2017 10:01 am

Re: Folders scanning

Postby 3Dscrewer » Thu Jul 25, 2019 8:23 am

Try this .....

https://discourse.osmc.tv/t/error-your- ... -utf/70339

and this ...
https://discourse.osmc.tv/t/why-ship-os ... y-pi/21827

utf-8 will have the most specific symbols.

Good Luck
3Dscrewer
 
Posts: 197
Joined: Tue Feb 13, 2018 1:11 pm


Return to Help

Who is online

Users browsing this forum: No registered users and 68 guests